RCM-28
Description
OMNEO Network and DSP Module for Tour Grade Amplifiers
The RCM-28 Remote Control Module is a two-channel digital controller module for live sound reinforcement, PA and fixed installation applications. The module can be used in Electro-Voice TourGrade amplifier models. Installing the RCM-28 turns a conventional amp into a remote amplifier, which, at any time, provides complete overview of the overall system status and control of all system parameters. RCM-28 modules allow the integration of amplifiers into an OMNEO network with up to 100 devices in a single subnet without additional hardware. OMNEO is a media networking architecture for professional applications. Using standard IP Ethernets, media products that integrate OMNEO can be assembled into networks of 2 to 10,000 cooperating devices that exchange studio-quality synchronized multichannel audio and share common control systems. This offers the possibility to control and monitor an entire sound system from one or more PCs using the IRIS-Net - Intelligent Remote & Integrated Supervision - software package. In addition to digital signal processing functions, the RCM-28 also offers a digital audio input (AES/EBU), OMNEO network audio inputs and outputs, and freely programmable control inputs and control outputs.
Features
- OMNEO Network Interface
- Extend Tour Grade performance with powerful DSP functionality
- Advanced FIR-Drive loudspeaker optimization
- High precision load impedance supervision
- Two GPI and two GPO ports
- One-button system test for fast, complete check of connected cables and components
- Pilot tone detection for cable supervision
- Six recallable DSP/configuration presets
- Compatibility with any Dante network
Spesification
- A/D Conversion : 24 Bit linear, sigma-delta, 128x oversampling
- Analog Inputs :
2 audio inputs on internal slot connector, pre-/post fader selectable
- CAN Bus Interface : None
- Control Protocol : OMNEO
- D/A Conversion : 24 Bit linear, sigma-delta, 128x oversampling
- Data Format :
24 Bit linear A/D and D/A conversion, 48 Bit processing
- Digital Inputs :
Omneo Network and AES3 (AES/EBU) format, XLR in/ thru connectors
- FIR-Drive : Yes
- GPIO Control Ports :
1 x 6-pole Euro block 2 control inputs (Uin max. 5 V) 2 control outputs (2x 100 mA) 2 reference outputs (+5 V, 200 mA; GND)
- Internal Processing : Dual core DSP, 500 MIPS
- Network Control (IRIS-Net) : Yes
- Sample Rate : 48 kHz
- Sample Rate Conversion (SRC) :
32–192 kHz, internal samplerate- converter
- Signal-to-Noise Ratio (A-weighted) :
ADC: 120 dB typical DAC: 120 dB typical AES3: 128 dB typical Analog In to Analog Out: 116 dB typical dB
- THD+N : < 0.002 %
- Height : 2RU 80.4 mm
- Width : 84.7 mm
- Depth : 230.8 mm
- Weight Net : 400 g
Support & References
OFFICE & CONTACT :
|
PT. Davindo Sukses Mandiri Lindeteves Trade Center Lt. 2 Blok C-25 No. 7 - 8 Jl. Hayam Wuruk No. 127 Jakarta-11180, Indonesia |
||
|
Telp Fax |
: : : |
+6221-6220 0362 +6221-6220 1283 +6221-6220 1460 info@davindo.co.id |
OUR PRODUCTS
|
- Bosch Conference System - TOA Conference System - Televic Conference System - EV Sound System - Dynacode Mixer Audio |
OUR SERVICES :
